Audi 100/A6

1990-1997 of release

Repair and car operation



Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
- 3.3. Removal and partition of engines
   + 3.3.2. Technical characteristics
   3.3.3. Repair work, possible without engine dismantle
   + 3.3.4. Major maintenance
   3.3.5. Removal and engine installation
   3.3.6. Engine partition
   + 3.3.7. Head of cylinders
   3.3.8. Pistons and rods
   + 3.3.9. Cranked shaft
   3.3.10. Intermediate shaft
   3.3.11. Block of cylinders
   3.3.12. Radical bearings and bearings of rods
   3.3.13. Piston rings
   3.3.14. The first start of the engine after a partition
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


ff85f19c

3.3.14. The first start of the engine after a partition

PERFORMANCE ORDER
1. Without establishing a spark plug, turn a cranked shaft of the engine a starter, the alarm bulb of pressure of oil will not go out yet.
2. Establish spark plugs and connect wires of a high voltage.
3. Start the engine and warm up it to normal working temperature. Check the engine on existence of leakages of fuel, oil and cooling liquid.
4. Muffle the engine and check level of oil and cooling liquid.
5. The first 600 km do not give big load of the engine and watch oil level.