3. Remove the furnish panel under a steering column.
4. Disconnect a rope from a pedal of an accelerator and remove a rope.
Installation
Installation is carried out upside-down removals.
Adjustment MODELS WITH THE MECHANICAL TRANSMISSION
PERFORMANCE ORDER
Adjust the provision of a metal clip on a rope braid that at completely squeezed out pedal of an accelerator the butterfly valve was completely open.
MODELS WITH THE AUTOMATIC TRANSMISSION
PERFORMANCE ORDER
Establish the block, in the thickness of 9 mm between a pedal of gas and a floor and press a pedal to the block. Adjust the provision of a braid of a rope on the butterfly valve case so that the butterfly valve was completely open. Check operation of the switch of fall of transfer.
