Audi 100/A6

1990-1997 of release

Repair and car operation


Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
- 4. Cooling system
   4.2. Technical characteristics
   4.3. Hoses of system of cooling
   4.4. Radiator
   4.5. Thermostat
   4.6. Cooling fan
   - 4.7. Switches and sensors of system of cooling
      4.7.2. Diesel engine (2,0 l)
      4.7.3. Diesel engine (2,2/2,5 l)
   4.8. Water pump
   4.9. The heat exchanger масло-/cooling liquid
   4.10. Diagnostics of malfunctions in a contour of circulation of oil
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


ff85f19c

4.7. Switches and sensors of system of cooling

 TEMPERATURE SWITCH OF THE FAN OF COOLING

Check

Look subsection 4.6.

Removal

PERFORMANCE ORDER
1. Partially merge cooling liquid.
2. Disconnect the socket of connection of the switch and unscrew the switch.

Installation

Installation is carried out upside-down removals.

THE SENSOR OF TEMPERATURE OF THE ALARM BULB COOLING THE LIQUID / SWITCH

Both sensors are established in one module.

Identification of plugs of the sensor of temperature okhdazhdayushchy the liquid / sensor of an alarm bulb (3-штырьковый I will corrode connections)
1. Plug of an alarm bulb
2. Weights plug
3. Plug of the sensor of temperature

Identification of plugs of the sensor of temperature okhdazhdayushchy the liquid / sensor of an alarm bulb (4-штырьковый I will corrode connections)

 + – the food plug
With – the plug of an alarm bulb
R–conditioner plug
T–plug of the sensor of temperature

Check
PERFORMANCE ORDER
Check a food and grounding of sensors. Check resistance of sensors at various temperature of cooling liquid. If sensors are faulty, it is necessary to replace them.

Removal

PERFORMANCE ORDER
1. Partially merge cooling liquid.
2. Disconnect the socket of connection of the sensor.
3. Unscrew or remove sensors and remove a sealing ring.

Installation

Installation is carried out upside-down removals.

TEMPERATURE SENSOR OF SYSTEM OF INJECTION OF FUEL

If the sensor fails, on an instrument guard should light up
alarm bulb of system of injection of fuel. For sensor check
it is necessary to address to experts.

Removal

PERFORMANCE ORDER
1. Partially merge cooling liquid.
2. Disconnect the socket of connection of the sensor.
3. Unscrew or remove sensors and remove a sealing ring.

Installation

Installation is carried out upside-down removals.

TEMPERATURE SENSORS of SYSTEM of PRELIMINARY HEATING (DIESEL ENGINES in VOLUME of 2,4 l)

Removal

PERFORMANCE ORDER
1. Partially merge cooling liquid.
2. Disconnect the socket of connection of the sensor.
3. Unscrew or remove sensors and remove a sealing ring.

Installation

Installation is carried out upside-down removals.