Audi 100/A6

1990-1997 of release

Repair and car operation


Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
+ 8. Systems of start, ignition
+ 9. Transmission
- 10. Brake system
   + 10.1.2. Shock-absorbers
   + 10.2. Technical characteristics
   10.3. Pumping of hydraulic system
   10.4. Hydraulic tubes and hoses
   10.5. Brake overlays of forward brakes
   10.6. Brake overlays of back wheels
   10.7. Brake shoes of back brakes
   10.8. Brake disk of a forward wheel
   10.9. Brake disk of a back wheel
   10.10. Brake drum of a back brake
   10.11. Support of a forward brake
   10.12. Support of a back brake
   10.13. Wheel cylinder of a back brake
   10.14. Main brake cylinder
   10.15. Brake pedal
   10.16. Vaakuumny amplifier
   10.17. Vacuum valve of a servoamplifier
   10.18. Rope of the hand brake
   10.19. Lever of the hand brake
   10.20. The valve of adjustment of pressure in a contour of back brakes (to 96 g of century)
   10.21. Switch of fires of a stoplight
   10.22. General description of system of anti-blocking of brakes (ABS)
   10.23. ABS system elements
   10.24. Vacuum pump (diesel and petrol engines in volume of 2,3 l)
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


ff85f19c

10.21. Switch of fires of a stoplight

Removal

PERFORMANCE ORDER

1. The switch is established on an arm of a pedal of a brake. The switch of fires of a stoplight (1) is the top switch on an arm. The bottom switch (2) is the system switch cruise control.
2. Remove the shelf under an instrument guard and the relay panel.
3. Disconnect the socket of connection and unscrew the switch.

Installation and adjustment

PERFORMANCE ORDER
1. Check reliability of a fixing clip of the switch.
2. Squeeze out a brake pedal, insert the switch into a fixing clip and establish it in a nest. Adjust position of the switch, having slowly released a brake pedal.
3. Further installation is carried out upside-down removals.