Audi 100/A6

1990-1997 of release

Repair and car operation


Audi 100/A6
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 3.2. Diesel engines
+ 3.3. Removal and partition of engines
+ 4. Cooling system
+ 5. Heating and ventilation
+ 6. Fuel system
+ 7. Exhaust system
- 8. Systems of start, ignition
   - 8.1.1. Introduction
      8.1.2. Technical characteristics
      + 8.1.3. Accumulator
      + 8.1.4. Generator / system of additional charge of the accumulator
      8.1.5. Replacement of the holder of brushes and regulator of tension of the generator
      8.1.6. Check of system of start of the engine
      8.1.7. Starter
      8.1.8. Inlet gas pipeline
      8.1.9. Cable gas/lever of a butterfly valve (DB)
      8.1.10. Cable of management of gas (DB)
      8.1.11. Contour of fuel of the diesel engine
      8.1.12. Prestarting heating of diesel fuel
      8.1.13. Fuel thermostat
      8.1.14. Hydrovalve case
      8.1.15. Cable gas/lever of a butterfly valve (DD)
      8.1.16. Cable of management of gas (DD)
   + 8.2. Ignition system (petrol engines)
   + 8.3. System of prestarting heating (diesel engines)
   + 8.4. System of production of exhaust gases
+ 9. Transmission
+ 10. Brake system
+ 11. Suspension brackets, steering
+ 12. Body
+ 13. Electric equipment
+ 14. Good advice


ff85f19c

8.1.5. Replacement of the holder of brushes and regulator of tension of the generator
PERFORMANCE ORDER
1. Remove the generator.
2. Turn off fixing screws (are specified by shooters).
3. Release clips.
4. Uncover.
5. Turn off fixing screws and remove the holder tension brushes / regulator.
6. Measure length of brushes of the generator in points And and V.Zamenite the holder together with brushes if it is necessary.

7. Examine a surface of tokosjemny rings (are specified by shooters) and replace them if it is necessary.
8. Assembly of the generator is carried out upside-down.